DSTWO PLUS run emunand demo

GG34

Note:


DSTWO PLUS run emunand demo

Centho

This do not work on version 10 etc right ?

GG34

Centho replied at 7-11-2015 05:16
This do not work on version 10 etc right ?

Works on new 3ds (Firmware 8.x and 9.2).

Kayleea

My 3ds console version is 4.5.0-10U. I have a supercard DSTWO PLUS.
I try to run EmuNand with the DSTWO PLUS following the guide in your video.
But after I clicked "Nintendo DS Profile" , the upper screen did show the gateway image, however the lower screen just being black screen, which didn't give me the choice for "boot gateway mode" or others. And after a few seconds, it directly went back to the home menu screen.
Could you pls tell me why I was unable to run emunand with the DSTWO PLUS ??
Thanks.

shanefromoz

Just reset your 3ds and load exploit again

Kayleea

I tried but failed. What's the reason ?

shanefromoz

Do u have the Gateway launcher file in the root of your 3ds sd card?

GG34

Kayleea replied at 9-11-2015 19:16
My 3ds console version is 4.5.0-10U. I have a supercard DSTWO PLUS.
I try to run EmuNand with the DS ...

You should hold L button when upper screen did show the gateway image.

fuctface

Kayleea replied at 10-11-2015 03:55
I tried but failed. What's the reason ?

Before you launch gateway menu you have to start the ALEX RIDER icon in the 3DS home menu and once it loads choose the GW icon. Then press 'A' to install and follow the directions. I imagine you just didnt install the Gateway plugin to the supercard. I did that too before lol.  

Kayleea

GG34 replied at 11-11-2015 17:32
You should hold L button when upper screen did show the gateway image.

Thanks.  I finally got it work by holding the L button.
Appreciated for your help.